Automotive fog lights are an indispensable safety event for those who aware in areas prone to early Forenoon fog. Wiring an after-market fog flash tools requires a basic generous of electrical wiring, safety and the Correct tools. Doing the duty yourself Testament save you the reward of having an automotive shop complete it for you.
Instructions
1. Set a habitat on the front bumper where you are going to install your Car fog lights. Normally, this Testament be low to the ground. Whether feasible, the address should be one that Testament own the mounting bolts to come in contact with the frame of the vehicle for worthier grounding.
2. Mount the lights to the bumper or frame using the hardware supplied in the after-market utensils. This Testament normally consist of self-tapping mounting screws or a method with a bolt, washer and locking seed. Provided self-tapping screws are not supplied, you Testament occasion to exercise the drill and an appropriately sized bit to drill mounting holes for the bolt to activity finished.
3. Disconnect the negative battery terminal on the automobile battery before attempting to associate any wiring. This safety method Testament prevent viable sparks that can flame fumes from distinct sources on the machine. It again prevents you from accidentally shorting elsewhere the battery.
4. Route the wiring from the fog lights finished the vehivle's firewall to the sprint inside the van. The wiring Testament pep through the supplied two-way switch before being routed to the battery for connection to the power source. Be sure to avoid any moving parts under the hood. It is best to follow already-installed wiring harnesses and secure the wire every few feet with zip ties or electrical tape.
5. Locate a spot on the dash where you will mount the fog light switch. Install the switch with the hardware provided in the kit.
6. Connect the wire running from the lights to the switch. Run remainder of the wire from the opposite side of the switch to the battery's positive cable. This will ensure you have power to the switch. Alternately, the power can also be derived from the fuse box under the dash. This alternate method is sometimes preferred because it will automatically shut off the lights when the ignition is turned off, thus preventing accidental drain on the battery.
7. Ensure that the auto fog lights are properly grounded on the front of the vehicle. Reconnect the car's negative battery cable, and test the lights for proper working condition. If any adjustments need to be made or any loose connections are found, always be sure to disconnect the negative battery cable before working on the wiring.
If the mount is not connected directly to a part of the frame, then you will need to run the ground wire supplied to a self-tapping screw and washer onto a location on the frame. Most bumpers are mounted directly to the framework at two or more points on either side of the radiator. Look for these contact points, and mount the grounding wires there if applicable.8.
