Newer example, volume transmission equipped Isuzu vehicles, further a hydraulic method to function the clutch. The clutch pedal is attached to the clutch adept cylinder. Urgent the clutch pedal down pushes a piston inside the master cylinder forward. This forces hydraulic fluid elsewhere of the crack cylinder along a hydraulic limit to the clutch slave cylinder. The fluid moves a petite piston inside the slave cylinder which is connected to a pushrod. This pushrod forces the clutch regulate.
Instructions
Open the slave cylinder bleeder screw, by turning it counterclockwise. Have an assistant pump the clutch pedal until clean brake fluid seeps out of the bleeder screw. Then close the bleeder screw. Make sure the clutch master cylinder does not run dry.
It Testament be located in the engine bay on the Chauffeur side of the firewall, near the brake crackerjack cylinder. Fill the reservoir with Spot 3 brake fluid. Engage in not own the reservoir to fall dry at any day during the bleeding development.
3. Set the clutch slave cylinder. It will be bolted to the clutch housing. Locate the small bleeder screw near where the hydraulic hose connects to the slave cylinder.
4. Connect a length of clear plastic tube to the bleeder screw.
5.1. Stand the vehicle and flotation with jack stand placed underneath the frame.2. Remove the involve from the reservoir on top of the clutch proficient cylinder.
6. Have the assistant pump the clutch pedal a few times and hold it against the floor. While the pedal is held against the floor, open the bleeder screw and allow the some fluid to seep out. Close the bleeder screw before releasing the clutch pedal.
7. Repeat the process listed in the step above and watch the fluid seeping out of the slave cylinder. The clutch is fully bled when there are no more air bubbles in the fluid seeping out of the slave cylinder. You will be able to see the bubbles in the clear plastic tubing. Do not allow the clutch master cylinder to run dry at any point.
8. Lower the vehicle.
.jpg)
.jpg)
