overhead DVD Player installation instruction manual

how to install overhead dvd player

Installing overhead DVD Player is worth the money and quite rewarding in the long run, but an overhead DVD player is made up of several parts at the start. A green hand or someone who has a very limited knowledge of overhead DVD player can also mount the overhead DVD player on his own.(Audi gps navigation)

But with certain knowledge and understanding in this aspect, you can carry out the installation process faster. Moreover, the implementation of the overhead car DVD player installation itself can help you save the setup costs to a certain extent. Browse through the remarks on Internet for reference when it comes to making purchase of overhead DVD player. If there is any doubt on the equipment and specifications, you can gain support from factory.

Now let’s get started and see how to install overhead DVD player.

Install an overhead DVD player
Step 1
Find installation location for the overhead car DVD system. Make sure that the position can help you put the screen into the back of the car effortlessly. Completing the dome light may be needed.
Step 2
Devise a survey of the bracket, with the system on the headliner of the car where it was selected to be the system constructed. Ensure that the lines are centered on both sides of the vehicle.
Step 3
Partially covered car headliner, however, you have to ensure that you throw just one side so that the arrangement of the cable through. Screw the sun visor on the fuse box on either driver side or the passenger side. Draw the connections to disconnect the vanity light. Pry out the top and underneath pillar trim in the same direction from which you use a flathead screwdriver to take out the sun visor. Bound a seat belt, if it is found connected to the upper column. The seatbelt is usually fixed with a head or bolt. Dismount any screws and mounting brackets, and remove the kick panel above the fuse box and the position of the panel on the side.
Step 3
Cut the lines on the car headliner. Make sure that a support beam above the place where you intend to put up the system runs. When no such a jet is found, insert the wooden rail on the roof of the car. Set for the holder to mark at least four holes on the support beams or wood. Make sure you center the holes on the beam hole.
Step 4
Align the cable coming with the system through the headliner. Ensure enough room for the connection to the player. Make use of the hardware coming with the overhead DVD system. Only a few systems, you would have all the cables with the DVD system prior to installation to connect. Put the cable assembly in the back of the panel. Mount the bracket eagerly using short screws coming with the car DVD system. Join the Dome wires to the corresponding lines according to the guidelines in the DVD player manual.
Step 5
Connect the power cable and audio cables. All cables should are connected to a 12-volt source without the black cable which should be grounded. You can do the grounding with a screw. Apply roller guide wire to cut the wires and use electrical tape to secure cable connections. Position the FM modulator under the seat where it is removed the cover from the next. Set up the audio cable to the FM modulator. Set the modulator into any radio signal as mentioned on the modulator. Fixed position of the wires, where the panels would be replaced. Mount seat belts, panels back.

You May Also Like