Available on account of 1999, the Chevy Silverado exists in multi-platform incarnations, including cloudless, bulky, diesel and hybrid. It won Engine Trend's Motor lorry of the Year award in 1999, 2001 and 2007. Published as a workhorse, the Silverado comes equipped with a haul and tow funds to transport excessive or enormous loads. Research the Chevy Silverado fuel delivery transaction provided the engine runs Rugged, stalls or cuts outside while driving.
Instructions
1. Proceeds the Chevy Silverado's fuel delivery manner's compel. Disconnect the refusal battery cable and loosen the fuel fill cap. Disconnect the water-in-fuel sensor from the fuel filter.6. Remove the fuel filter and visually check it for clogs. Reinstall the fuel filter if it is in good working order.
There shouldn't be any fuel begun in the contour. Provided there is, the engine problems are practicable caused by a defective fuel pump vigour regulator, which method the fuel is flowing back into the lines instead of into the engine and there is not Sufficiently fuel in the engine for Correct service. Whether there is no fuel in the lines, reattach the vacuum edge and hang in with the fuel delivery diagnostic.
3. Reconnect the battery and twist off the fuel energy approval Harbour cap. Attach a fuel impulse check gauge to the fuel power valve. Turn the engine on and let it sluggish. Proof the gauge. It needs to glance at between 55 and 62 psi. Pressure that's too high or too low may mean the fuel pump is malfunctioning or the fuel filter is clogged.
4. Remove the pressure gauge. Disconnect the negative battery cable again.
5. Drain fuel from the fuel filter. Attach one end of a hose to the water drain on the water-in-fuel sensor. Place other end of the hose into a container approved for holding fuel. Disconnect the water-in-fuel sensor harness connector and then disconnect the fuel filter from the fuel filter and heater element housing. Envelop a towel over the fuel pressure Schrader valve becoming to protect from any pressurized fuel spray.2. Disconnect the vacuum limit from the fuel pump power regulator and test for fuel. Touch to the owner's tome for the string's objective provided you aren't undeniable which one it is.
Replace the filter if it is clogged, if it's been more than one year or more than 15,000 miles since the filter was replaced.
7. Clean the fuel filter and heater element housing. Check the filter for a possible problem filter seal. Coat an intact seal with clean engine oil. Connect the water-in-fuel sensor. Install the filter onto the fuel filter and heater element housing. Connect the water-in-fuel harness connector and negative battery cable.
8. Prime the fuel system after reinstalling or replacing the fuel filter. Pump the primer on top of the filter 30 times or until it's stiff. Start the engine and let it idle for five minutes. Visually check for any leaking fuel.
