You can install a Flowmaster exhaust yourself.
5. Insert the 2 1/2-inch exhaust clamp on the reduced end of the inlet pipe. The reduced end is the end that is smaller in diameter than remainder of the pipe. Place the reduced end onto the stock exhaust head pipe and hand-tighten the clamp nut.6.
Remove the full of years exhaust from the vehicle from the headers. Abbreviate the inventory exhaust into sections with a sawsall for child's play Emigration.
2. Discern what type of mannequin F-150 you chalk up and the length of the Bedstead by referring to your owner's volume.
3. Trim the inlet main provided needed using a sawsall. The inlet channel needs to be trimmed for the discrepant Bedstead lengths 2006 F-150s had. Provided your vehicle is a public cab short Bedstead, you Testament commitment to trim 18 1/2 inches. Twelve inches commitment to be trimmed provided your vehicle is a supercab with a 5.5-foot Bedstead. Six inches charge to be trimmed provided your vehicle is a supercrew pattern with the 5.5-foot Bedstead. You bring about not need to chop the inlet pipe for other models.
4. Apply a small amount of anti-seize compound to the threads of each exhaust clamp. Spread the anti-seize lubricant around the threads using your finger.
Adding a Flowmaster exhaust to your Ford F-150 can edit the potency and performance of your Motor lorry. Flowmaster exhaust systems are larger, which allows also air to Way out the engine. This Testament authorize the engine to escape cooler and also efficiently. Flowmaster exhaust and replaces the muffler for a deeper-toned sound from your exhaust. These directions are for installing a Flowmaster exhaust action to a V8 Ford F-150 Motor lorry.
Instructions
1.Insert the hanger into the factory hanger bushing and push the inlet pipe through the hanger so that the hanger is holding the rear end of the inlet pipe. Hand-tighten the clamp with your hand.
7. Slide another clamp over the end of the inlet pipe. Insert the end of the muffler into the end of the inlet pipe and tighten the clamp using your hand.
8. Place another clamp onto the rear of the muffler exit pipe. Place the tailpipe into the muffler exit pipe and tighten the clamp hand tight. Make sure the tailpipe is installed over the rear axle of your F-150 truck.
9. Place another clamp on the end of the tailpipe and insert the tip into the tailpipe. Tighten the clamp hand tight.
10. Make the necessary adjustments to the exhaust system to line the exhaust components up. Tighten the clamps using a ratchet and socket starting with the front of the vehicle and working to the rear.
