A pop-up sunroof is a glass panel that can be tilted or removed To admit for increased airflow and ablaze. Manually operated pop-up sunroofs can be installed in most vehicles and are the least expensive type of sunroof to invest in.
Instructions
1. Buy a pop-up sunroof installation equipment from an Car parts store or online. Sunroof sizes can span from environing 12 by 36 inches to 22 by 38 inches, so be undeniable To gauge the roof of your vehivle before you purchase. You'll require to go-ahead at least a foot of room on either side of the decrease gap.
2. Disconnect your vehicle's absent battery cable, as you might carry to reroute some electrical wiring in categorization to full the installation method.
3. Degree the spot for the sunroof by using the printed template that Testament be included with the installation instruments. Centre the template on the roof of your machine, ensuring that it's in the exact accommodation you craving it. Hint approximately the edges of the paper template with grease pencil, then tape down the edges to influence the template in deposit for the mo.
4. Drill a aviator gap wound up the roof of your automobile in the domicile indicated on the template.
Clean the frame with rubbing alcohol, then remove the adhesive, protective primer and sealer from the kit. Carefully apply these items by following the manufacturer's guidelines.10. Install the inner ring and tighten the bolts from the inside of the vehicle.
Remove the paper template and make an outline around the grease pencil markings using masking tape. The outline will serve as a guide as you cut the roof.
7. Cut the hole by inserting the jigsaw blade or a nibbler into the hole you drilled in step 4, then cutting along the taped area. Use extreme caution when cutting this area and work slowly.
8. Verify that the frame of the sunroof fits properly in this hole. The frame should have a snug and secure fit. Use tin snips to remove any rough spots, remove the tape from the roof and replace the headliner.
9.5. Remove the headliner from the interior roof of your automobile. Depending on the architecture of your vehicle, you may get to disconnect dome lights, compartments for garage-door openers or sunglasses or anything else that falls into the nature where the hole will be.6.
This holds the sunroof in place.
11. Install the pinch molding and vinyl trim. Remove the debris from the installation process.
12. Install the glass, the two front hinges and the rear latch. Confirm that the sunroof works properly.
