Replace Rear Wheel Bearings On The Ford Explorer

Shove bearings are prone to wear during a motorcar career and may exigency to be replaced.


The rear turn bearings on a Ford Explorer are prone to wear and Testament eventually entail replacement. This is oftentimes signaled by an audible hum while driving the machine. Becoming replacement parts can be expensive, whether you accept the vehicle to a shop, so bright exchange rear rotate bearings on a Ford Explorer can save you method.


Instructions


Seperate the upper ball joint from the wheel knuckle, by removing the nut and bolt. Again, the nut can be discarded. Push the outboard CV joint loose of the hub, and store it in a safe place. Push the axle to ensure it is disengaged from the hub. Disconnect, and remove, the tire meeting from latest the circle. Allot, and remove, the bearing kernel and the washer that comes with it. Provided a au courant aficionado came with the replacement bearing, you can discard the infant devotee; otherwise, garner it sheltered.


2. Remove the bolts from the back of the brake caliper bracket. Ownership the caliper while removing the bolt, to prevent it falling and poor the brake limit. Slide elsewhere the brake caliper. Seperate the toe link from the rotate knuckle, by removing the peanut and bolt. The kernel can be discarded.


3.1. Situate chocks under the front wheels of the Explorer, to prevent the automobile slipping while you are working. Lift the rear of the van on a automobile jack. Remove the first off rear revolve. Remove the nut and bolt. Remove the wheel knuckle, the hub and the bearing as one assembly. Remove the three bolts on the assembly.


4. Remove the hub from the wheel bearing. Take out the retainer ring, and remove the wheel knuckle from the bearing. Attach the wheel knuckle to the new bearing, and install the retainer ring. Insert the new wheel bearing into the replacement hub. Reassemble the assembly by re-installing the three bolts. Install the assembly in the car around the axle, and re-attach the nut and bolt to hold the assembly in place.


5. Attach the wheel knuckle to the upper ball joint with a nut and bolt. Re-attach the toe link to the wheel knuckle with another nut and bolt. Install the brake caliper, and hold it in place, while you re-attach the bolts on the back of the brake caliper. Replace the wheel bearing nut and washer. Re-attach the tire assembly and the tire. Lower the car on the jack. Repeat for the other rear wheel.