The brakes in your vehicle rely on properly functioning brake lines.
Brake lines are the tubes that transact brake fluid from the crack cylinder to the brake caliper. When you push the brake pedal in your vehicle, brake fluid is forced on ice the brake lines to your brakes, which causes them to squeeze the rotor and conclusion your vehicle. Whether the brake lines fail, fluid Testament leak away and you Testament lose braking ability. It is salient to alternate your brake lines these days when failure occurs so that you Testament be able to close the vehicle properly.
Instructions
1. Jack up the rotate, using a floor jack, which you are changing the brake column for. Area a jack stand underneath the circle and lower it until the weight of the vehicle is supported by the jack stand. Remove the revolve from the vehicle and allot it aside.
2. Disinfected the Seam, which the brake line is screwed into at the brake assembly, of any debris that may be near the Seam. This prevents any debris from getting into the brake development and causing malfunction.
3. Abode one wrench on the Seam and one wrench on the becoming on the brake wrinkle. Turn the wrench on the becoming while holding the Seam in community with the other wrench. Advantage a extract pan to select any fluid that may leak elsewhere of the brake column.
4. Remove the other purpose of the schism contour at the master cylinder by using a wrench to loosen the Trimmings. Deed down the full length of the brake line and undo any clips that are holding it in corner. Remove the brake borderline from the vehicle and discard it.
6. Attach the other end of the brake line to the master cylinder by screwing the fitting into the master cylinder. Move along the brake line and attach the line to any clips that hold it onto the vehicle. Make sure that the brake line is protected from rubbing against any moving parts on the vehicle and is not bent or kinked in any way.
5. Screw the au courant brake string into the joint at the brake assembly replacing any washers, or gaskets, that were found on the old line. Use two wrenches, one to turn the fitting and the other to hold the joint in place.
7. Fill the vehicle with brake fluid and bleed the system to make sure there are no air bubbles present. After the brakes are properly bled, put the wheel back on the vehicle and use the floor jack to life the vehicle off of the jack stands and back onto the ground to complete the installation.
