Motor lorry accessories untrue to add style and personality to your Motor lorry includes cab lights. But, installing them fair makes the discrepancy between adding to or beguiling outside from the Motor lorry's d cor. Regardless of the style or Trade-mark of cab lights chosen, installing them is something the do-it-yourself consumers can install successfully. Provided you are exceptional with a drill and a screwdriver, then you obtain the fundamental skills. As with any project that requires working with electrical systems, protect yourself and the action by disconnecting the gift source.
Instructions
1. Place the screws holding the sun visors in area and back them away with a star screwdriver. Pull the visors from the roof of the cab.
2. Proceeds the covers and lock mechanism of the grab hilt on the passenger side of the cab. Pull the employ away until it is for free.6. Cover the installation area with masking tape. Place the lights back in their locations and trace the screw holes onto the cab.
The column insert is the portion running from the top of the dashboard to headliner.
4. Back elsewhere the front screw in the overhead console. There is a clamp on Everyone side at the back, so pull down on the back to gratis the console from the overhead. Provided the vehicle has OnStar, disconnect the speaker plug and the map luminosity. Remove the console.
5. Levy the sidelights 4 1/8 inches back from the windscreen gasket and 4 1/4 inches from the door gasket. Dominion the centre brilliant the same distance from the windshield gasket and in the center of the cab. Stare at the lights from the front of the truck for the correct position.
You achieve not hold to grip it gone of the headliner.3. Pry the driver side and passenger side support covers free ride with a straight screwdriver. Start with the center light to keep from reaching over the sidelights.
7. Drill the holes with a 7/64-inch drill bit. Insert rubber grommets in the holes to protect the wires from shorting out against the metal.
8. Connect the wires to the lights and feed them through the holes in the cab. Put some silicone sealer on the screws and install the lights. From inside the cab, run the driver side wires with the center and passenger side wires and feed them down the passenger side pillar to the fuse box.
9. Wire the fused lead to the hot wires from the lights and attach a female connector on the ground wire. Connect the power and the ground wires and test the lights. Once tested, reassemble the overhead console.
