Connecting the wiring for a van stereo depends a collection on how the stereo's wiring is allot up. Whether it has an electrical connector that Testament donkeywork with your specific vehicle, connecting it is Unceremoniously. Otherwise, you essential to figure elsewhere which stereo wire connects to Everyone vehivle wire. The stereo's volume or the vendor's tech branch should guidance you with this.
Electrical Connector Wires
Once you be cognizant which wires are which, you can seperate the function wire (normally burgundy or unethical) and the ground wire (nearly always ebon). Everyone wire needs a half-inch of insulation stripped off. One fashion to associate a stereo wire to the machine's wire is terminated crimping. The wires are twisted calm while lined up side by side (production the connexion glance akin a triangle purpose) and then inserted into a crimp connector. Most of the day the wires Testament be 18 gauge, so dash off confident the connectors are the go dimensions. You can then tighten the connexion by applying a crimping part in the Centre of the cap
You can and solder the wires stable. For this, you obligation to twist the wires together so they form a straight line. When using the soldering iron, make sure the solder from its spool touches the wire while you heat the wire with the iron. If you insulate the wires with electrical tape, don't expect it to last forever, which will eventually cause the wires to short out. A better method is to use heat-shrink tubing and a heat gun.
Power Wire
The power wire will need to be connected in one of two ways. Once you have located such a screw, fit the wire lead under it by loosening the screw just enough to fit the wire lead underneath and then tighten the screw back. If the wire isn't touching bare metal, the stereo won't work when you turn it on. If the connection is loose, you will likely get noise interference on your radio signal. Reaching the battery requires you to route the power wire through the car's firewall to the engine compartment.
Ground Wire
The ground wire must be firmly connected to a metal ground on the car. The best place is on the chassis, underneath a screw or bolt connected to an area of bare metal. Most of the time, it requires a switched power source. The wire lead will connect to the electrical connector for another in-car device connected to the car battery. A high-powered stereo can require a constant power source directly from the battery. This will use a heavier gauge wire and requires an in-line fuse (the stereo should include this) and a ring terminal to connect the wire to the battery's positive terminal clamp.
