Replacing the door glass on a Camaro is binding whether the glass is chipped or broken. Assign the item between the Eccentric person and the door. Toggle it until the clip comes elsewhere. Slide the Eccentric person off its shaft.2.
Instructions
1. Remove the window Eccentric person using a horseshoe-clip removing item. You can expect this project to appropriate the fitter stuff of a hour. When you modify the door glass, it is a bad conclusion to prop the door sincere using a breeze block or capacious brick. This eliminates having to encounter with consideration the door open while dealing with the glass and other parts of the door.
Unscrew the armrest and the door lock doorknob. On some models, there may be other screws inside the door pulls. Disengage the circlip from the door hook pull rod. Remove these items.
3. Haul off the dwarf metal clips from the edges of the trim panel using a Hairpin puller. Advantage this factor to remove the "Christmas tree" plastic clips without bad the hardboard backing on the trim panel. Lift the door trim panel straight up. It should come gone easily. Evaluation the action of the inboard door felt and the tar-paper moisten seal, and convert them whether needed.
4. Remove the outer window felt using an counterbalance screwdriver. Appropriate outside the plastic rivets, provided any, using needle-nose pliers.
5. Unbolt the two stabilizers atop the door. You too posses to remove the lower and upper stops to receive the glass out. To remove the front upper stop and rear upper stop, crank the window to three-quarters of the way down. To remove the stop bolts that are in slotted channels, remove the front and rear lower sash channel nuts.
6. Back out the adjustment of the front and rear upper guide bolts that control the in-out tilt adjustment, and carefully lift the old glass out.
7. Put in the new glass. Swap the hardware that is in the old glass to the new one using common hex bolts. To transfer the forward bell crank assembly that is retained in the old glass with special two-hole nuts to the new glass, a homemade two-pronged tool or Snap-on S9610 is needed.
8. Loosen the star-shaped plastic guide that helped the old glass from rubbing in the track and snap it on to the new glass. This can be done using only your hands. Wiggle it back and forth and lower the new glass into position.
9. Bolt the front and rear sash channel nuts to the glass and reinstall all the other mechanisms in the door.
