A screwdriver is the one factor requisite to remove a headliner.
The Chevrolet HHR headliner, existence larger than many automotive headliners and of single-piece interpretation, is substantially deeper ball-buster to remove than some other automotive headliners, expressly when you're trying to prevent damage. In attempting to remove an already damaged headliner for replacement, less annoyance is cardinal when preparing the interior for the easiest installation of the replacement headliner.
Remove the Vehicle's Pillar Trim
You must remove all the sections of peristyle trim from the pillars when attempting to remove a headliner from any vehicle. The pillars on the HHR are located between the windows, and they are constructed of plastic. Glance for any round plugs that might go underground the pole trim mounting screws. In the event of the HHR, the two pillars to the sides of the windscreen are attached to the window frame without screws. You can pull these elsewhere of their mounting holes, however be careful to avoid poor the trim as you pull it gone. The rear window trim Testament be mounted with screws. Remove the screws and the trim Testament pull easily gone.
Remove the Cabin Light Fixtures and Sun Visors
It's big-league to remove the cabin flash fixtures and sun visors before attempting to remove the vehicle's headliner. The sun visors are attached to the frame of the van using three screws. Pull the sides of the headliner down, folding it in half. This Testament allow you to remove the damaged headliner through the back hatch of the car quickly and easily.
Removing an Undamaged Headliner
If you must replace the headliner at a later time, it is necessary to prevent the headliner board from being damaged.Removing a Damaged Headliner
There are two options for removing the headliner at this speck. In the contingency of a damaged headliner being replaced, it is prime to manage the rear hatch and assign the back seats and front seats down as Apartment lodgings as practicable. Grasp the sides of the headliner with your hands and position one of your feet in the centre of the headliner. Remove these to Proceeds the sun visors and obtain them gone of the form. Remove the overhead burnished by prying off the sunshiny plastic clear housing and locating the mounting screw located inside the housing. When you remove the screw, the housing Testament come costless, however the wiring Testament at the end. It is first-rate to pull the wiring connectors off of the connector pins to avoid damage to the illumination housing by trying to push the integral housing fini the opening in the headliner.
This can be done by first laying the front and rear seats down as far as they can go and opening the rear hatch. Turn the headliner at an angle so that one side is near to the roof of the car, while the other side is touching the seats, then pull the headliner out through the rear hatch of the car at this angle to prevent damage to the sides or middle of the headliner.
