Repairing your van paintwork isn't always a badger.The tint pen is a relatively latest notion on the mart. It is a inconsiderable vessel of paint that has a pen applicator for a gratuity. This tint pen is simply shaken and then pressed onto the chip or scratch. You Testament communication that the distemper flows actual slowly and in a miniature stream from the cusp of this paint-pen gratuity.
There are a hardly any ways to create it intelligible, efficient and cheap. There are diverse methods when repairing any beneficent of paintwork on your automobile from scratches and chips to copious dents and scrapes. Everyone one Testament restore the van to a like-new action and prevent corrosion of the exposed metal.
Paint Pens
So to handle, establish the pen gratuity honorable in the centre of a scratch, press down and action the pen along the scratch. For immature chips, fair-minded press down on the pen and the chip Testament fill with colouring.Larger Chips
For larger chips that can't be repaired with a stain pen, employment the brush applicator that is included in the whitewash pen. Dip the brush into the dye, then mop off excess and handle the paint to the area of the scratch. Make sure the area is cleaned with a light solvent or soap and water to remove grease and dirt beforehand. For the best application, always shake or stir the paint before use.
Dents and Scratches
Dents and large scratches that are more than a few inches long will require spray paint. This is similar to the top-coat paint that is applied to your vehicle at the factory. One way to apply this is to first sand the area lightly with 220-grit metal sandpaper. Then tape off the area to be spray painted. Cover the entire surrounding area with plastic and tape it down so it does not move. Then spray on one coat of the touch-up spray paint. Let dry and coat it again. Large repainted areas should be covered with a clear top coat to preserve the paint and create a glossy shine.
Repainting Large Sections of Your Car
If you need to repaint large sections of your car, use a primer under the new paint. This primer prepares the surface for the paint and allows for better hold. The top-coat paint will stick much better to this surface than it will to ordinary metal due to its characteristics. Any color of primer can be used, but to be exact, find out which type of primer your manufacturer uses by visiting their website, or ask your auto dealer.
