The drive shaft and habitual joints on your vehicle may acquire damaged or wear gone over bout, causing vibration or clang during operation, manufacture it essential to disconnect the shaft for work. Much though the handle shaft has the needful vigour to deliver rotating influence, you should arm it with apprehension. Any bitty dent you may inadvertently assign on it Testament author it to vibrate during development.
Prepare the Drive Shaft for Removal
However, make sure to tighten the vise on the shaft flange to prevent damage to the shaft body.To separate the universal joints, place the sockets on each opposing cap and use the vise to push on the sockets. The smaller socket will help push into one of the caps while the other will catch the opposite cap as both become loose.
Disconnect the Drive Shaft
When ready, disconnect the rear yoke from the differential and the centre cooperate member from the cross member, whether your replica is equipped with it. Let the rear of the drive shaft rest on a jack stand or Element that Testament avow you to keep the rear of the shaft close to a horizontal position. This will prevent damage to the extension housing, rear busing and front universal joint, says James E. Duffy in "Modern Automotive Technology."
On some drive shafts, the caps of the rear universal joint on the drive shaft may become loose after disconnecting the shaft from the differential. You may want to wrap masking tape around the caps to prevent them from falling off and spilling the roller bearings inside.
With the rear and center disconnected, pry the drive shaft forward to separate it from the differential flange. Pull the drive shaft off the transmission extension housing and out of the vehicle.
Remove the Universal Joints
Use a vise to remove the universal joints from the drive shaft.
If you are servicing the universal joints on the drive shaft, make scribe marks on the components so that you may reassemble them in their same exact position. The joints can be separated form the drive shaft by using a vise, a socket larger than the caps and a socket smaller than the caps.Properly assist your vehicle on four jack stands so that you can attempt comfortably under the vehivle. Before loosening the drive shaft mounting bolts, scribe matching marks on the rear meeting, which includes the differential flange, rear yoke (the movable Element on the rear of the manage shaft that connects it to the differential) and the replica of the impel shaft consequent to the rear yoke. And, scribe matching marks on the centre Supple Seam, provided your specific design is equipped with it. This Testament assist you reinstall the shaft in its corresponding position to garner it balanced and to prevent any problems during step.
