The Chevy Silverado 1500 uses both brake pads and shoes on the rear wheels. The shoes are much larger than the ones used on other vehicles. Make sure you get the correct type of pads for your model. The rear brakes use a type of horseshoe-style single brake shoe on each wheel that is clipped in place, making replacement slightly simpler than on most other vehicles.
Instructions
Removal
- 1
Raise the Silverado's rear end, making sure the truck is parked on a level surface, and support it on jack stands. Remove the rear wheels, block the front ones and release the parking brake.
2Compress the two caliper pistons with a C-clamp. You will likely need to remove two-thirds of the brake fluid from its reservoir under the hood prior to this using a suction tool. Watch the fluid level as you compress.
3Remove the lower bolt for the brake caliper with a flare-nut wrench, holding the slide pin in place with an open ended wrench. Pivot the caliper upwards.
4Remove the brake pads from the caliper mounting bracket.
5Clean the mating surface on the caliper bracket with a wire brush and rag, then apply a very thin coating of high temperature grease to the surface.
6Install the replacement pads in the mounting bracket.
7Lubricate the caliper slide pin with the grease, then pivot the caliper back down and apply the mounting bolt.
8Reconnect the wheels and lower the truck after changing all the brake pads.
Shoes
- 9
Raise the truck and remove the rear wheels as described in Section 1, then unbolt and remove the caliper completely from the brake disc. Hang this caliper from somewhere on the chassis with a strong wire.
10Remove the caliper mounting bracket from the brake disc, removing its own mounting bolts with your wrench.
11Pull the disc off the wheel and hub.
12Unbolt and remove the single clip holding the brake shoe in place at the bottom using a small wrench.
13Slide the brake shoe off the actuator, then lift, bend and work it around and over the axle flange to remove it.
14Install the replacement shoe around the axle and actuator, seating each end into the ends of the adjuster wheel. If they won't fit, turn the star wheel with a screwdriver until the slots run parallel to the backing plate. Bolt the clip into place.
15Reconnect the brake disc, caliper mounting bracket and brake caliper.
16Reconnect the wheels and lower the truck.