How to Change Corvette Brake Pads

The Chevrolet Corvette uses brake discs on both the front and rear tires, as these provide superior stopping power for high performance cars. These discs are squeezed by thick pads that stop the wheels when breaking. Eventually these pads wear thin and will need replaced; this is usually indicated by delayed braking or squeaking sounds. Changing out the break pads is not a difficult task, but it requires patience and care to be done properly. It also helps to have some basic knowledge of auto repair.

Instructions

Park the Corvette on a level surface. Set the parking brake to keep the car steady while you're working on it.

Pop your hood and disconnect the negative battery cable.

Jack up the car near the wheel where you will be changing the brake pad first. Raise the car up until the tire is just off the ground.

Remove the tire and set it aside along with the lug nuts.

Put a large C-clamp around the caliper body (the part holding the pads). It should be positioned against the rear of the caliper body and the out-facing pad.

Tighten the C-clamp to compress the pistons. Remove the bolt atop the caliper (upper caliper bolt) and pull the caliper downward at an angle until you have enough clearance to safely remove the pads.

Spray the caliper and brake parts with some brake bad cleaner and wipe it down with a rag to remove most dirt, grease and grime.

Slide the outboard pad and its insulator in the caliper then place the inboard pad with the wear sensor into the caliper pistons. Press the pads firmly until are fully seated within the caliper.

Pivot the caliper upwards until it can't go any farther then tighten the bolt until its secure.

Place the wheel and tire back on the car, bring down the jack and repeat the entire process with the three remaining wheels.