Dragging brake pads on a Chevrolet Silverado will cause the pads and rotors to prematurely wear. When replacing brake pads, there are a few things you should do to ensure the pads and rotors have the longest life as possible. Rather than rush through a simple brake job, take the time to service the brakes properly to maximize braking efficiency and brake life.
Step 1 Lift the Chevrolet Silverado with the jack and place it on jack stands.
Step 2 Remove the wheels with a lug-nut wrench and set them aside.
Step 3 Remove the caliper with a ratchet and use a bungee cord to hang the caliper. Do not let the caliper hang from the brake hose as it might break and cause fluid to leak.
Step 4 Pull the brake pads out of the brake caliper bracket. If they don't come out easy, you can use a flathead screwdriver to pry between the brake pad and the rotor.
Step 5 Sand the brake pad holder with 500-grit sandpaper until you see bare metal. If any corrosion remains on the holder, the brake pad will stick.
Step 6 Sand the edges of the brake pad where it makes contact with the brake pad holder. Sand until it is smooth.
Step 7 Place the brake pads back into the brake caliper bracket.
Step 8 Remove the pins from the caliper and clean them of any grease. Place new brake anti-seize onto the pins and put them back into the caliper.
Step 9 Open the master cylinder reservoir so you don't break a seal while compressing the brake caliper.
Compress the brake caliper with a C-clamp so the caliper can fit over the new brake pads. Install the caliper by securing it to the brake caliper bracket with a ratchet.
Tip: A brake caliper compressor might work better for you than a C-clamp.
Warning: Wear safety glasses while working on your brakes.
Items you will need: Jack, Jack stands, Ratchet, Sockets, Flathead screwdriver, Sandpaper, Brake anti-seize
