A leaky muffler can fabricate a quota of bang.
Fix the muffler on your vehicle -- it is the oval-shaped can at the rear of the exhaust pipes. Visually scrutinize the muffler and establish the hole.3. Wipe the entire muffler clean, using a shop rag with a soap and water mix. It is relevant to seal any holes in your muffler as soon as viable seeing exhaust leaks are harmful to the universe, noisy and can authorize fumes to infect the passenger cabin. This repair project is straightforward and requires peerless a rare tools.
Instructions
1. Hoist the rear of the vehicle with the floor jack and position the jack stands under the jacking points on Everyone side of the machine. Lower the vehicle onto the jack stands and liberty the floor jack in berth for following convenience.
2.After you've owned a automobile for a infrequent dotage, the muffler may be in commitment of youngster repair. It might be damaged by bounce with debris on the method or could fall basket case to the corrosive tool of rust. A petite gap in the muffler can be repaired using muffler tape. This tape is designed to bond to the metal muffler using heat from the exhaust.
Allow the muffler to air dry thoroughly.
4. Pull the paper backing from the muffler tape and start wrapping the muffler a few inches from the hole. Overlap the tape about one inch each time around the muffler.
5. Continue wrapping until the hole is completely covered and the muffler tape extends one inch beyond the hole on the other side.
6. Lift the rear of the vehicle off of the jack stands with the floor jack. Remove the jack stands and lower the vehicle to the ground. Pull the floor jack out from under the vehicle.
7. Start the engine and let it idle for about 15 minutes to bond the tape to the muffler.
