Remove a 2002 Ford Windstar Alternator
The alternator on a 2002 Ford Windstar plays a too chief effects in the engine's charging development. The alternator keeps the battery charged and the engine running. When an alternator starts to receive debilitated, the lights on the automobile dim and the battery becomes weaker. Once the alternator fails completely, the battery goes dead and the engine Testament not Eccentric person. You can alternate the alternator on the 2002 Ford Windstar in approximately one day.
Instructions
1. Set the serpentine girdle tensioner on the front of the engine. Remove the serpentine girdle by putting a ratchet with a 15-mm socket onto the bolt purpose that is in the centre of the sash tensioner. Turn the zone tensioner clockwise and pull the serpentine band elsewhere from the alternator pulley.
2. Disconnect the annulling battery cable from the batter advise with an frank head wrench and locate the cable gone from the assign so that it Testament not touch it.
3. Unplug and unbolt the electrical connections on back of the alternator. There Testament be a wire plugged into the back of the alternator and a wire that is bolted into the back of the alternator. Adoption a ratchet and a 5/16-inch socket or an unbolted borderline wrench to remove these electrical connections.
4. Remove the alternator bracket bolts. There are two bolts in the front of the alternator bracket and one bolt in the back of the alternator bracket. Use a ratchet and socket for the front two bolts and an open end wrench for the back bolt. Pull the alternator bracket out.
5.7. Place the new alternator into the mounting bracket and put the pivot bolt back through the alternator and the power steering pump and tighten it down very tight.8.
6. Put the pry bar under the alternator and pry straight up on the alternator. Pull the alternator out of the mount and set it to the side.
Remove the big bolt that goes through the top of the power steering pump and into the alternator. This is the bolt that allows the alternator to pivot. Pull the bolt all the way out and set it to the side.
Put the alternator bracket back on the alternator and tighten the front two bolts and the one rear bolt.
9. Reconnect the electrical connectors to the backside of the alternator. Insert the one plug and bolt the other plug into the back of the alternator with the ratchet and 5/16-inch socket.
10. Put the serpentine belt back on the alternator pulley by putting the 15-mm socket back on the ratchet and putting it on the center bolt on the belt tensioner. Pull the tensioner clockwise and slide the belt over the alternator pulley.
11. Reconnect the negative battery cable to the battery. Crank the engine and make sure that the new alternator is charging. You can do this by looking at your gauge or by hooking a voltmeter to the alternator.
