Customizing a motorcycle is a awash deal and an expensive proposition in some ways, nevertheless you can fabricate some in reality fine parts that constitute your bike stand elsewhere, including the motorcycle seat. A motorcycle seat is not clear to conceive, however provided you are used to working with metal, it is not exact tough either.
Instructions
1. Reduce your steel to the Rugged shape you wish. Green light approximately a 1/2 inch enclosing the path of the seat. This item Testament be curled into shape using a steel roller, so permit Sufficiently to accomplish the length of curl you wish. Chronicle for the curl in your initial shape originate.
2. Dart the seat column terminated the metal roller or pincher using the go bits for the curl shape you wish. Round off the abundant borderline of the episode roughly.
3. Decide assemble your seat pan, with a "bucket" or concave curl to fit your specific bike and rear end. Then turn the seat upside down and lay it on a mallet bag or form. Pound in the bucket or curl shape for the seat using a mallet.5. Measure your leather or skin for the bike seat. This measurement will be a lot larger than the foam measurement. Cut a rough shape first, from your measurements, then lay the leather or skin on the seat, and line it up to chop a more precise fit.
Measure out the foam pieces for the total width of the seat, including the curl, then leave and extra 1/2 inch. Cut the foam and apply it to the seat using double sided tape. Make sure it covers the entire seat. Apply the glue liberally and evenly, then apply the foam and let dry. Apply another layer of foam if desired. You can also use neoprene or another soft, water proof material for this step.
Do this until you form the natural concave shape that makes your seat a little more comfortable and keeps you on the bike. It should also match your overall vision for the bike.4.
6. Rivet the seat leather to the bottom of the seat using a rivet gun. Go ahead and rivet it to the flat area of the seat, or the side curl, if you want the rivets to show through. That is a cool look. Another idea is to drill holes in the seat pan itself, and lace the leather through to attach it to the pan.
7. Add your seat hardware and attach to the bike.
