Where to Install
A flow valve is meant to close off a hydraulic manner when a firm bigness of impulse exists thanks to manner. This is to protect the Engine and touchy parts from damage. So, the flow valve must be installed where it can protect the Engine. The cool position for the flow valve is deserved in the intake of the Engine housing. This intake is where the hydraulic fluid enters the mechanism. It is normally located on the side of the box later to the fly shove or Engine turbines.
Installation Tips
When installing the flow valve, aboriginal accept the right-sized Element to fit your appliance. Most motors Testament notate the bigness of the inlet Harbour in their documentation. The flow valve Issue must just these size (expressed as a thickness). Provided you hope for to employ a flow valve that is larger or smaller, you can, on the contrary you will have to use an attachment diameter, and this may not be the right solution for every machine. Once you have the proper diameter valve, thread it into the intake and tighten with a hex head wrench. Then connect the hydraulic hose to the flow valve.
Other Considerations
This requires closing the needle valve and completely shutting down the hydraulic pump, which feeds the fluid into the motor. Before you attach the hose, you must also "deadhead" everything so there is no flow. Then reset the pumper to its slowest rating and begin to circulate fluid through the pump and into the motor. If there is limited space, find another component. Installing a valve that may come in contact with other moving parts or makes the connection to the hydraulic hose can cause the machine to malfunction.
Attaching the Hoses
Hook up the hydraulic hose once the valve is connected.The flow valve should be set to shut when a pressure level is reached; this level should be listed on the flow valve meter. If not, set some flow valves to certain pressure ratings, but the most simple are preset to shut at one pressure rating. Attaching the flow valve to the engine will add some additional space in the gap where the hose attaches to the motor. Monitor the system and reduce the flow if the valve shuts down the machine.
