Public automotive starter Engine
The starter motor in your Nissan Maxima is hermetical inside the engine compartment, however once you remove the air intake assembly, changing the Engine is a incomplex engagement. You yet carry to accept firm precautions. But, adjacent these little steps, you Testament be able to transform the starter in a event of minutes.
Instructions
1. Field your automobile in a protected community with Sufficiently period for you to endeavor encompassing the front of the van. Extensive the hood.
2. Disconnect the atramentous, anti battery cable.
3. Unplug the Bulk airflow (MAF) sensor electrical connector, whether your specific mould is equipped with one. The sensor is located on the air duct of the air intake meeting. Good press the lock tab to Proceeds the connector conformation the wiring harness.
4. Remove the air intake meeting. On some models, you will have to remove hose clamps and mounting bolts securing the air intake assembly to the engine and engine compartment. Depending on your particular model, you may need a screwdriver, Phillip's screwdriver, a wrench, or a ratchet and socket. Once you remove the assembly, you should be able to see and have access to the starter motor.
5. Disconnect the power or battery cable form the starter solenoid using a wrench or ratchet and socket. The starter solenoid is mounted on top of the starter.8. Install and tighten the two mounting bolts. Plug the wire electrical connector and install the power cable to the starter solenoid.
Remove the two mounting bolts form the starter motor using a ratchet and socket. On most Maxima models, take note of each particular mounting bolt location since one is shorter than the other one and can only be reinstalled on the same location. You might need a ratchet extension to arrive the mounting bolts.
7. Remove the starter motor off the engine compartment and set the new motor in place. Make sure the motor mounting surface is flush against the surface mounting base. This will avoid the starter pinion gear grinding against the flywheel gear and subsequent damage to the starter motor and flywheel.
To possess access to the cable connector, lift the protective rubber boot, then unplug the electrical connector form the wire coming out of the starter solenoid. Just press the lock tab to release the connector from the harness.6.
9. Install the air intake assembly, and plug the MAF sensor electrical connector. Then connect the black, negative battery cable.
