Alter The Positive Battery Cable Around The Starter

Over generation, battery cables can corrode and grow into stain. When either occurs, the magnitude of electricity that flows wrapped up the cables is reduced. With knowing wear, there Testament not be Sufficiently happening on ice the cables to properly activate the starter. The sole fashion to resolve the complication is to transform the cable. To alter the decided battery cable on the starter, displace the steps below.


Instructions


1. Put rotate chocks carry on Everyone rear tire.


The starter sits between the engine and the transmission, usually on the passenger's side of the vehicle.8. Locate and remove the battery cable that is attached to the side of the starter.


Jack up the front of the van and ease the vehicle with two jack stands which are rated to safely buttress the weight of the vehicle.


4. Clear the hood of the vehicle and fix the convinced and anti terminals on the battery. The certain terminal Testament be pronounced with a "+" notice, while the annulling terminal Testament be glaring with a "-" notice.


5. Disconnect the negative battery cable from the battery by using a wrench to loosen the bolt which attaches the bad battery cable to the battery.


6. Disconnect the positive battery cable from the battery by using a wrench to loosen the bolt which attaches the positive battery cable to the battery.


7. Locate the starter motor underneath the engine.2. Handle the parking brake.3.


The cable can be removed by removing the nut which holds the cable to the starter with a wrench.


9. Trace the cable from the starter to the starter solenoid with your hand to locate the starter solenoid.


10. Remove the starter cable from the solenoid by removing the nut which attaches the cable to the solenoid with a wrench.


11. Attach one end of the new positive battery cable to the solenoid by sliding the cable over the stud on the solenoid and securing the nut over the cable end.


12. Attach the free end of the cable to the battery cable post on the starter by securing the nut over the cable end.


13. Reattach the positive battery cable to the positive battery terminal.


14. Reattach the negative battery cable to the negative battery terminal.