Motor lorry covers that attach with Velcro accept a smooth finished appearance--until the Velcro wears outside. Then the edges orifice, and the sagging involve can develop into lenghty. Some covers all the more extreme up torn or completely disappeared provided they come loose and flop enclosing in the wind while the Motor lorry is Stirring. Putting modern Velcro on the include Testament save you cash through it is less expensive to interchange the Velcro than it is to exchange a damaged or forfeited involve.
Instructions
1. Degree the length and wideness of the encompass before buying your Velcro. It Testament normally be between 22 and 26 feet whether the complete length is covered.
2. Turn the involve upside down and bring about to chop concluded the aged stitching that holds the Velcro on the contrary end not abbreviate the insert. When the Velcro starts to lift out from the contain, you can pull it gently away from the subsume and intersect the threads between the comprehend and the Velcro. Amass going until all of the Velcro has been removed from the embrace. It Testament come off faster this way than by cutting one stitch at a time.
Apply heat to the old Velcro with the heat gun set on low. Setting the heat gun on high can strip the paint.6. Try to sew over the old stitch line so it will not show. Stop 2 inches back so you have room to chop the Velcro.
4. Cut the Velcro when you come to the ends. If the Velcro that is attached to the truck is still good, you can stop here.
5. Hold the heat gun 4 inches away from the Velcro at first--you can move it closer if the Velcro does not release.3. Line the new Velcro up with the old stitching line. Place the edge of the cover under the foot of the threaded sewing machine.
Move the heat gun in a smooth and continuous motion without stopping in any one place to avoid ruining your paint job.
7. Remove any leftover adhesive with the adhesive remover and a soft cloth. It will not make any difference as far as the paint, but the new Velcro will attach better if the surface is thoroughly cleaned.
8. Check to see if the paint is shiny and smooth. If it is shiny, gently sand only the very thin strip where the new Velcro will be going. The paint needs to be free of wax, and it needs to be applied to a slightly rough surface. If it is attached to a surface that is too smooth, it can peel off in the heat.
9. Peel off a foot of the backing and fold the edge down, then attach that section following the lines of the old Velcro. Pull another foot off and attach that section. Continue until the new Velcro has been attached to replace all of the old Velcro.
.jpg)
.jpg)
