Replacing or flushing the coolant in a Honda needs to be done every two to three years--not counting refilling the coolant receptacle when it's low. The coolant process is what keeps the engine running at optimal levels. It very prevents the engine from over-heating. Maintaining the coolant system is chief for the health of the vehicle. Failing to arrange this not difficult repair can cause costly damages in the engine. Equal a couple tools and approximately an lifetime of lifetime can prevent this.
Instructions
1. Adjust decided the engine is gelid before replacing the coolant. Removing the radiator cap before the engine is chill can bob to injuries from steam and heat.
2. Pop the engine hood and contemplate for the radiator. The radiator is a enormous block located on the Chauffeur's side of the vehicle with many hoses running to and from it.
3. Replace the drain bolt and the radiator cap. Unscrew the cap on the coolant tank which is a clear tank on the passenger-side of the vehicle. Pour in coolant up to the "Cool" fill line. Replace the cap.
Remove the filter bolt located later to the radiator cap with the socket wrench.
5. Corner a bucket underneath the motorcar consequent to the radiator cock pin. This pin is on the backside of the radiator and looks close a large screw with wings to help turn it. Loosen the screw and let the coolant drain out of the car for 10 to 15 minutes until it stops.
6. Remove the bucket, screw the cock pin back in tightly. Manipulate a towel to unscrew the radiator cap. Deposit the towel over the solid radiator cap, push down the cap and turn to the condign.4. Close the hood.
