Lifetime the lowest Motor lorry on all sides of is the objective for many enthusiasts. Lowering the Motor lorry's suspension used to be the individual plan to energy, however momentarily you can permanently lower the complete Motor lorry by performing a target Blop. This Testament annex your Motor lorry touching the ground, no concern what amount wheels you admit. Become able entity Blop a Motor lorry and acquire your Motor lorry sitting lower than remainder.
Instructions
1. Remove everything you can from your Motor lorry. Accept gone all of the seats, Floor-mat and flammable data from the cab. You will have to change matters in your engine bay, on the contrary the dimensions Testament vary between models.
2. Decide how many inches you hankering to elevate the floor. You must abbreviate the entire floor and re-weld it a few inches higher than stock. This will cause the outside of the truck to become very low to the ground. The average is 2 to 5 inches. Anything more than 5 inches is very extreme. Performing a 3-inch body drop will cause the outside to look much lower than 3 inches.
3. Measure and mark a line where you will be cutting. Keep in mind that if you raise the floor too much you will have more work in the engine bay and the interior. You will have to move the gas and brake pedals and many parts under the hood.
4. If you get it too hot it will warp and change shapes. Proceed slowly.7. Close in any gaps with sheet metal. You must also cut the connections where the cab is connected to the frame rails.
5. Mark a line around the inside of your truck bed. Repeat the same steps for cutting the truck bed.
6. Weld the floor into place using tack welds to hold it, and then go around and weld the entire thing. Sheet metal on trucks is very thin and becomes hot easily. Cut along the line that you made with a plasma cutter. You can use a sawzall, but a plasma cutter will create smoother lines. Cut the back and sides of the cab and along the firewall.
You will have gaps under the doors where water and road debris may build up and cause rust. Fit and cut sheet metal for this area, and weld it into place.
8. Drive your truck only after you have completed the body drop and safely replaced all of the parts and driving components.
