Degree for a Driveshaft
Lower the hydraulic jack slowly and remove it once the rear wheels are on the ground. Supply all measurements taken to your machine shop or hot rod shop To possess a new driveshaft fabricated. Before a modern driveshaft can be fabricated, you Testament necessitate to receipts the true measurements to insure it fits properly.
Instructions
1. Field the vehicle on alike ground and application the parking brake. Corner a hydraulic jack under the rear of the vehicle's frame and stand the jack until the rear wheels are off the ground. Put a jack stand under Everyone side of the rear axle housing and lower the hydraulic jack.
2. Crawl under the vehicle and convenience a measuring tape and degree from the vertical surface of the rear of the transmission to the Apartment lodgings surface of the rear differential yoke. (This is where the rear U-joint bolts to.) Cause a note of this measurement.
3. Measure the rear differential yoke between the locating tabs and make a note of this measurement.
4. Push in on the tail shaft of the transmission. Now measure Until when the tail shaft sticks out past the end of the transmission case. Make a note of this measurement.
5. Measure the diameter of the U-joint cap that fits into the differential yoke and make a note of it.
6. Raise the rear of the vehicle with a hydraulic jack high enough to remove the jack stands from under the rear axle housing.A driveshaft is a metal tube that delivers influence from the engine and transmission to the rear axle on rear-wheel coerce cars and trucks. The coerce shaft is connected to the transmission tail shaft and to the rear axle differential with U-joints To admit for the up-and-down activity of the rear suspension. Provided you decide to alternate your vehicle's drivetrain for racing or calescent rodding, chances are you Testament committal to swap your vehicle's ride shaft with a unit to match your current engine, transmission or rear axle meeting.
