If the water pump is faulty in your Mercury Cougar, this could cause all kinds of problems in your engine. The water pump is the heart of the Cougar's cooling system, circulating the coolant. To prolong the life of your vehicle's engine, make sure to change out a bad water pump.
Instructions
2.0L Cougar Engine
- 1
Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan
2Disconnect the negative battery cable before you begin.
3Remove the accessory drive belt and timing belt and disconnect the lower radiator hose.
4Loosen and remove the bolts to the water pump and take the pump out of the engine.
5Install the new water pump, tightening the bolts to 12 to 15 foot pounds (16 to 20 Nm).
6Reinstall the accessory drive belt and reattach the lower radiator hose.
7Reconnect the negative battery cable and refill the cooling system.
8Start the vehicle and inspect for leaks when it reaches to normal operating temperature.
2.5L Cougar Engine
- 9
Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan.
10Disconnect the negative battery cable.
11Remove the water pump pulley shield and the water pump drive belt. Disconnect the coolant hoses.
12Loosen and remove the three bolts to the water pump and remove the pump and the pump housing. Separate the pump from the housing.
13Attach the new water pump to the pump housing, tightening the fasteners to 16 to 18 foot pounds (22 to 25 Nm).
14Install the new water pump with the housing to the engine, replacing the 3 bolts and tightening them to 11 to 13 foot pounds (15 to 18 Nm), plus 85 to 95 degrees. You must replace these three bolts because they are designed torque-to-yield.
15Reattach the coolant hoses and the water pump drive belt with the pump pulley shield.
16Reconnect the negative battery cable.
17Refill the cooling system, start the car and check for leaks once the engine reaches normal operating temperatures.
