1. Only the professional installing technicians are allowed to install and maintain this product.
2. Installation or maintenance by the unprofessional people might cause electric shoke or other risks and even damage the unit.
3. In the process of connecting, pay attention to the hook position, don't pull wires forcibly to avoid invalid connection.
4. Please use the attached wire of the system, otherwise the accident of fire or smoke or damage to the unit or vehicle might be caused.
5. Don't cut off any extra wire which is kept for future use, Protect the ends of wire with insulating tape.
6. In order to avoid short circuit, please disconnect the anode of the power accumulator before any connection and installation.
7. Ensure all lines are placed and protected in good condition, don't let them interfere in any moveable parts of the car such as steering wheel, gearlever, brake pedal, sliding chair, door or other parts.
8. The voice is input through AUX, so please ensure audio cable connectes well with the AUX port of the original car audio system.
9. The Peugeot 307 GPS can be fit for Peugeot 307.
1. Before installation.
2. Hold the bezel sides of display screen and pull it towards you to remove it.
3. Pry the glove box with crow plate
4. Pull the original head unit out with removal keys and disconnect the cables
5. Remove the ashtray
6. Remove the decorate trim as the picture show you.
7. Remove the two screws
8. Remove the trim plate as picture showed
9. Remove the decorate trim, and don't get these two clips loosen
10. Take the two small covers off with the removal tool
11. Disconnect the cables which connect to the button
12. Remove the four nuts
13. Remove the decorate panel and disconnect the cables
14. Remove the cover upper the brake pedal
15. Fish the harness which should be connected to the display screen through the dash.
16. A: frame B: 8 PIN cable C: 10 pin cable D :GPS antenna E: DVD trans-connecter F:powercable G: display screen H: DVD part
17. Install the display screen, and fish the USB cable through the hole shows in picture
18. Fish the USB cable through the dash and put them in the glovebox.
19. Fish the GPS antenna through the hole showed in picture and mount the GPS antenna in the corner of the dashboard, up against the windshield
20. Fish the DVD cable through this hole and connect with the display screen
21. Install the display screen, please note all the clips in place.
22. Pull out the DVD trans-connecter which connects with the head unit from the hole as picture shows. Do not block the air outlet.
23. Connecting all the harnesses of decorate plate and fix all the clips
24. Install the decorate trim to the car
25. Fix the four screws
26. Rress the buttons in position
27. Reassemble the decorate plate and install the fixing screws
28. Install the decorate trim
29. Install the ashtray
30. Remove the right and left brackets of the original unit and fix them in position, then connect all the harnesses
31. Push the head unit into the right place
32. Remove the original small screen, and keep the bonnet of buttons
33. Install the original screen and bonnet to the new plastic frame and buttons
34. Connect the cables of display screen and install the display screen
35. Reassemble the cover upper the brake pedal
36. Installation finished.
