1. O nly the professional installing technicians are allowed to install and maintain this product.
2. Installation or maintenance by the unprofessional people might cause electric shoke or other risks and even damage the unit.
3. In the process of connecting, pay attention to the hook position, don't pull wires forcibly to avoid invalid connection.
4. Please use the attached wire of the system, otherwise the accident of fire or smoke or damage to the unit or vehicle might be caused.
5. Don't cut off any extra wire which is kept for future use, Protect the ends of wire with insulating tape.
6. In order to avoid short circuit, please disconnect the anode of the power accumulator before any connection and installation.
7. Ensure all lines are placed and protected in good condition, don't let them interfere in any moveable parts of the car such as steering wheel, gearlever, brake pedal, sliding chair, door or other parts.
8. The voice is input through AUX, so please ensure audio cable connectes well with the AUX port of the original car audio system .
1. The original car center console
2. Pry the air-conditioner outlet with crow plate. Be care of the buckles
3. Remove the whole air-condition outlet .Take out the cables
4. Remove the screws between the original radio and monitor. Take care of the screws.
5. Pull out the original monitor
6. Remove the cables of the original monitor
7. The dashboard after removing the original monitor and the whole air-condition outlet
8. The original monitor after pried
9. Remove the screws and the bracket as showed in the picture.
10. Pull out the original monitor
11. Roadrover DVD navigation monitor
12. Fix the Roadrover DVD navigation monitor into the position of the original monitor
13. Plug in the socket as showed in the picture
14. The diagram of the Roadrover DVD navigation monitor after installation
15. Pull out original radio parts .Be care of the buckles
16. Take out the cables for original radio and plug in the cables for Roadrover radio
17. Connect the other side of the original power cables with the cables of roadrover unit
18. Pull out the other side of roadrover cables as showed in the picture
19. Fix back the original radio parts
20. Pull out the DVD connector to the locker in front of the second pilot seat .
21. Pull out the USB cables from the roadrover DVD navigation monitor to the locker in front of the second pilot seat
22. Fix back the cables of the roadrover DVD navigation monitor and fix the GPS antenna
23. Fix back the roadrover DVD navigation monitor
24. Fix the screws between the monitor and the radio parts
25. Fix back the original air-condition outlet
26. Connect the power cables between the DVD monitor and the radio
27. Fix the external DVD in the locker
28. Finish the installation, power on for testing
