Disc brakes are not only the safest and strongest brakes available for the 1992 Toyota pickup, they are also the cheapest and easiest to replace for the at-home mechanic. This is one reason why do-it-yourself mechanics are so happy with the Toyota pickup: It came equipped with four-wheel disc brakes. When it does come time to change them, all four tires can be done in about 2 hours.
Instructions
- 1
Loosen all the lug nuts one full rotation counterclockwise with the tire iron.
2Place the floor jack underneath the vehicle frame behind the driver-side front tire. Raise that side of the front of the pickup until the front tire is 2 inches off the ground. Set the jack stand under the frame and lower the pickup onto the jack stand. Remove the loosened lug nuts and remove the tire. Repeat the process for the opposite side of the front of the pickup.
3Loosen the bolt on the bottom of the brake caliper mounting bracket with the socket wrench. The mounting bracket is the bracket that is attached to the rotor behind the wheel.
4Pull the brake pads out of the bracket while you lift the bracket bottom into the air. The pads will simply pull out.
5Compress the brake caliper cylinder in the center of the bracket by pressing it in with your fingers or thumbs. If the caliper does not compress by hand, compress it with the C-clamp by setting the stationary end of the clamp against the rear of the bracket and the movable end against the cylinder, then tightening the clamp until the caliper cylinder is flush with the bracket.
6Place the new brake pads in to the slots the old ones were in. They will fit easily now that the caliper is pressed in.
7Bolt the caliper bracket back down to the rotor and set the tire on the rotor. Finger tighten all of the lug nuts and lower the vehicle. Tighten all of the lug nuts with the tire iron.
.jpg)
.jpg)
