 |
| audi gps navigation |
the following is the guides about How to install a car DVD Player for the Headrest? have fun here!!
How to Install a Car DVD Headrest Player
Personal car DVD players can be installed in a vehicle inside the front seat headrests for viewing by back seat passengers. Electronics and auto parts retailers offer gps DVD players specifically designed for this. Mounting such a player in the vehicle requires you to cut holes in the headrest itself. With some simple tools and 30 minutes, you'll have a your own mobile screening room.
Instructions
Things You'll Need:
* Paper clip
* Knife
* Screwdriver
* Rubber cement
1.Lift up the seat's headrest from underneath as far as you can then push the end of a paperclip into the hole in the headrest mount to disengage and remove it from the seat. Pull the upholstery off of the headrest.
2.Trace an outline of the DVD player's mounting frame on the back side of the headrest's foam using a felt tip marker.
3.Cut a hole in the foam with a knife around the drawn outline. Using the car DVD frame as a guide, hollow out the hole until the frame fits securely in the hole.
4.Slip the upholstery cover back onto the headrest.
5.Cut an "X" in the upholstery where it covers the hole in the foam using a knife. Fold the four triangle pieces from the cut down inside the hole.
6.Apply rubber cement to the bottom surface of the headrest hole.
7.Press the car DVD player's empty installing frame into the headrest hole once the rubber cement begins to mount. Wait for the cement to dry.
8.Locate the holes in the installing frame for routing the car DVD player's wires. Twist and drill into the foam through the hole using a Phillips head screwdriver.
9.set up the car DVD into the installing frame following the player's mounting instructions, routing the wires through the hole in the frame.
