Replacing the front brakes on the Dodge Ram truck is easy. The process is the same for both the two- and four-wheel drive models. You can expect each wheel to take about 30 minutes to do. You can replace the brakes in your driveway, so there is no need to spend money on a mechanic. You want to make sure that you examine the brake rotors, when you change the brake pads, to be sure there is no damage to them.
Instructions
- 1
Pop the hood of the Dodge. Locate the master cylinder at the back of the engine compartment on the driver's side. Siphon enough brake fluid from it so that the level is halfway between the minimum and maximum lines with a turkey baster. Put the fluid in a drain pan for recycling. Place a set of wheel chocks behind the rear tires. Raise the Ram with an automobile jack. Place a jack stand under the truck near the jacking point and raise it up to the frame. Remove the lug nuts with a lug wrench and pull the wheel off the vehicle.
2Remove the caliper bolts with a socket and ratchet. Pull the caliper away from the wheel assembly. Remove the brake pads from the caliper. Insert a piston tool into the caliper and turn it until the piston seats itself inside the caliper housing.
3Insert the new brake pads into the caliper. Place the caliper onto the mounting bracket and tighten the retaining pins with the socket and ratchet. Remount the wheel and tighten the lug nuts with the lug wrench. Remove the jack stand from under the Ram and lower the truck to the ground. Repeat the process for the other wheel.
4Add brake fluid to the master cylinder to bring it to the proper level once the brake job is complete. Pump the brake pedal until it feels firm.
.jpg)
.jpg)
