The Dodge Ram has endured many years and many generations in the Chrysler Corporation. In 2004, the Ram was available in 1/2-ton, 3/4-ton and 1-ton models. Available engine sizes ranged from a 3.7-liter 6-cylinder--available in the 1/2-ton series--to a 10-cylinder. The 3/4-ton and 1-ton models offered a 5.9-liter diesel engine or the infamous 5.7-liter Hemi engine, which was available in the 1/2-ton as well. While removing the brake rotors was basically the same for the 1/2-ton and 3/4 ton Rams, the 1-ton version added a slightly different procedure.
Instructions
- 1
Lift the Dodge Ram on a vehicle or truck lift to a suitable height to work on.
2Remove the lug nuts using an impact gun and a 7/8-inch impact socket or a 22 mm impact socket. Remove the center cap--secured by the tapered lug nuts--and then remove the wheel.
3Disconnect the two caliper bolts using a hand wrench. Pry the caliper and pad assembly off the rotor and support it to the suspension using a caliper hook or metal hanger.
4Remove the caliper adapter bolts using the impact gun and a suitable socket. Remove the adapter.
5Remove the rotor from the wheel hub assembly. This task may require cutting off rotor retaining clips from two of the lug studs if applicable. Removing the rotor may also require a variation of different procedures. If the rotor wiggles and moves, it will be able to be pulled off without incident. If it is stuck to the hub due to rust and corrosion, the reason it is being removed will have to be considered. If it's being removed and then reused, the rotor will have to be delicately removed with a three-pronged hub and rotor puller. If it is being removed for replacement, you can knock it off with a hammer, striking the flat plate on the edges of the rotor until it breaks free from the hub.
6Clean the surface of the hub facing and edges with a die-grinder and a coarse reconditioning disc before replacing the rotor.
.jpg)
