When the ABS warning light is lit on a Nissan Pathfinder, you have to change the ABS relay for safety reasons. The ABS relay controls the anti-lock brake system. Because of this, driving is unsafe while the ABS warning light is lit.
Instructions
- 1
Park the Pathfinder. Engage the parking brake. Open the hood and secure it using the safety bar. Disconnect the negative battery cable by loosening the nut on the clamp using an adjustable wrench. The negative battery cable is the black cable.
2Remove the quarter panel trim under the steering wheel by unscrewing the screws on both sides of the panel with a Phillips screwdriver. Look for the black protective box marked ABS. Remove this protective box by unbolting the four bolts using a 8mm hex socket. You should see the black relay.
3Unplug the wiring harness on the bottom of the relay by pressing the buttons on the side of the harness. Gently pull down on the harness while you are pressing the buttons. Once this is disconnected, remove the two mounting fasteners using a 8mm hex socket.
4Connect the wiring harness into the bottom of the relay. Replace the protective box and secure it by replacing the bolts. Replace the quarter panel trim and tighten the screws. Place the new ABS relay in the place from which you just removed the malfunctioning relay. Secure it by replacing the mounting fasteners. Tighten them with the socket.
5Replace the negative battery cable. Tighten the nut on the clamp. Close the hood. Start the vehicle. Look for the ABS warning light. If it remains off, test drive your vehicle by driving slowly and trying to stop. If it comes on, you should take your vehicle to a mechanic to service the system.
